Introduction:
This component is a 1.4‑liter hydraulic accumulator designed for waterjet cutting systems. It stores pressurized fluid and releases it on demand to dampen pressure pulsations, maintain stable system pressure, and provide instantaneous flow during peak demand.

Applications:
Used in high‑pressure waterjet cutting equipment to smooth pump output, reduce pressure spikes, and ensure consistent cutting performance. Installed in the fluid circuit between the intensifier pump and the cutting head.

Features:

• Capacity: 1.4 liters for adequate energy storage.

• Pre‑charged with nitrogen or inert gas for rapid response.

• Durable construction rated for ultra‑high pressures.

• Corrosion‑resistant internal surfaces for water and abrasive media.

• Reduces pump wear and prolongs component life by absorbing shocks.

Maintenance:

• Inspect regularly for external leaks, corrosion, or damage to the shell.

• Check and recharge pre‑charge pressure at scheduled intervals.

• Monitor system pressure stability; replace if pressure drops persist.

• Replace the accumulator if the bladder or diaphragm is damaged, or if the housing shows cracks.

• Not field‑repairable; replacement is recommended when performance degrades.